SLICEable
Shopping Cart (0)

How to apply

Watch & Learn: HTV Application Video

Step-by-Step Written Instructions

 

What’s in the Package:

  1. Carrier Sheet – Transparent plastic holding your design in place
  2. HTV Transfer – The actual iron-on decal
  3. Silicone Paper Cover Sheet – For the final sealing step

Before You Start

  • If using an iron, do not use an ironing board. Use a hard, flat, heat-resistant surface.
  • If your iron is smaller than the design, apply in sections.
  • Always preheat your iron or heat press.

 Iron Method:

  1. Set your iron between Cotton and Linen.
  2. Preheat the garment with the iron for 10 seconds.
  3. Place the transfer on the garment, carrier plastic facing up.
  4. Cover with the silicone sheet.
  5. Press firmly with the iron for 10–15 seconds per section, overlapping slightly.
  6. Remove the silicone sheet and let the garment cool for 2 minutes.

  7. Carefully peel off the plastic sheet.

  8. Cover again with the silicone sheet and iron for another 10 seconds.
  9. Check edges and corners. Repeat if necessary.

Heat Press Method:

  1. Set temperature to 190°C.
  2. Pre-press your garment for 10 seconds to remove moisture.
  3. Position the transfer with the carrier plastic facing up, design on garment.
  4. Cover with the provided silicone sheet.
  5. Press for 15 seconds.
  6. Let the garment cool down for 2 minutes (or wipe the plastic with a damp cold cloth).
  7. Gently peel off the carrier sheet.
  8. Place the silicone cover sheet back on and press again for 15 seconds.
  9. Check all corners. Repeat the final press if needed.

💡 Tips & Tricks

  • Using a hard, flat surface instead of an ironing board.
  • Applying extra pressure for larger designs.
  • Allowing the garment to cool before peeling the carrier sheet.

🧼 Care Instructions

  • Wait 24 hours before washing.
  • Wash inside out with mild detergent.
  • Avoid ironing directly on the design.​